How To Paint Flames On Your Motorcycle Or Chopper

Newbies information to portray hotrod flames.

Product and Provides

3/4 inch masking tape

Wonderful line 1/8 tape

600 and 1500 grit water-resistant sandpaper

x-acto knife

orange and pink paint for the flames

pre-cleaner

paint spray gun

airbrush

clearcoat

multi velocity polisher

buffing compound

Flames or any other graphics need to be painted on leading of a obvious coated foundation. Alongside with supplying the all round paint position more depth, implementing the artwork on major of the apparent coat helps make it possible to eliminate artwork with a rag and some thinner if you make a miscalculation.

Step 1:

With your 600 grit paper, extensively damp sand the crystal clear coat on the area you’re about to paint.

Phase 2:

With your great line tape, lay out the form of your flames, doing the job from left to appropriate. Press and pull the fine line tape into place with both of those hands doing the job in unison. Spend close awareness to the harmony of the region to be painted, and the background (that will be masked). If it appears to be difficult, never sweat it…you can expect to get the hang of it with a little exercise.

Action 3:

Right after you have got the flames laid out with the fine line tape, burnish it down good and limited to avert the paint from creeping less than the edge all through portray. This is particularly critical on the overlapping ends.

At the time the fineline tape burnished down wonderful and cosy, mask off the adverse (qualifications) regions with your 3/4 masking tape, thoroughly butting it against the edge of the fineline tape. Be cautious not to depart any gaps in between the masking tape and the fineline.

Stage 4:

With the flames thoroughly laid out and masked, it is really now time to spray some coloration.

Combine up some orange or yellow paint, and load it in your touch up gun. Use a few of skinny even coats, just more than enough to address. Following the foundation color for your flames have dried, load up your airbrush and insert some pink highlights to the recommendations and outer edges of the flames.

Move 5:

After the paint has dried, gently take away the masking tape by pulling it at a minimal angle away from the good line tape. Now remove the fineline tape working with the same course of action. Choose treatment not to peel up the edges of the contemporary paint.

Move 6:

Clear off any residue left by the masking tape with a clear soft rag and some pre-cleaner product.

Phase 7:

Time now to bury your flames below some apparent. Apply as many coats of apparent essential so that the edges of the flames are not able to be felt when you rub your hand around it (when it really is dry of course). If you can truly feel the edges of the flames by way of the crystal clear, you can will need to spray yet another round or two.

Step 8:

After the apparent has dried, damp sand it flat with 600 grit. Shortly immediately after you begin sanding you will detect ripples setting up to show up in the obvious. You may know you’re completed when the ripples vanish and the area is nice and flat. Soon after your completed with the 600 grit, moist sand it at the time more with 1500 or 2000 grit. At this position the crystal clear will seem hazy from wet sanding. Really don’t fret, that will all adjust following the up coming and closing phase.

Phase 8:

The remaining step is to buff the distinct coat to a mirror shine, using a multi speed polisher. Connect a foam buffing pad to the polisher, then load it up with some sprucing compound. There are quite a few various brand names of sharpening compounds on the market place, your regional vehicle overall body provide retailer will be ready to recommend a great 1. Retain the buffer going back and forth permitting the fat of the buffer do the perform. Do not keep in one place to long or you can expect to burn up by means of the clear. Retain buffing right up until you’ve bought a mirror-like complete.